Support plate Fiberlane 1" - Height: 100 mm - Lower edge to middle of drive shaft 62 mm
Product information "Support plate Fiberlane 1" - Height: 100 mm - Lower edge to middle of drive shaft 62 mm"
This high quality support plate from TGU works as a bearing for 42 mm drive shafts in ventilation systems in greenhouses. It has straight mounting holes.
This support plate is especially durable even under heavy weights thanks to a slide bearing, which is fitted with a special plastic ring. This bearing offers perfect slide effects and works as a substitute for grease.
Material: Galvanized steel
Mounting height: Lower edge to middle of drive shaft 62mm
This support plate is especially durable even under heavy weights thanks to a slide bearing, which is fitted with a special plastic ring. This bearing offers perfect slide effects and works as a substitute for grease.
Material: Galvanized steel
Mounting height: Lower edge to middle of drive shaft 62mm
Customers who viewed this item also viewed:
Offset bearing 1" - 50/50 - PU = 25 pcs
PU (Pcs): 25
This offset bearing has been developed for suspended shading systems with gable end drive. It brings the drive shaft to an optimal position and as a support point enables its rotation. The product has been built to hold trailing load. Material: High impact reistant plastic For mounting you will need the following parts: - M 8 x 70 bolt - M8 nyloc nut
0,00 €*
4 bearing shaft support 1" extended - PU = 20 pcs
PU (Pcs): 20 | Version: long
The 4 bearing shaft support has been developed for central drives in lay flat and in suspended shading systems. It works as a bearing point in the system and brings the drive shaft to an optimal position within the system. Short version for 34 mm tubes
0,00 €*
Steel tube, galvanized 1"
PU: loose
This steel tube is used as a drive shaft in shading and ventilation systems in large greenhouses. Due to its wall thickness of 3.25 mm, it is very resistant against torsion. The tube connector halves within our product range are used to connect the tubes. Diameter: 33.5 mm Wall thickness: 3,25 mm Length: 6050 mm Material: Steel, galvanized
0,00 €*
Steel tube galv. narrowed, 1'' / 2,5mm - L= 6,50 m - Bundle = 81pcs
PU: Bunch
This steel tube is used as a drive shaft for ventilation systems and large shading systems in greenhouses.Due to its wall-thickness of 2,50 mm, it is resistant against torsion.The tubes can be easily connected by inserting them into each other through their swaged ends and bolting them afterwards. Bolt M8 x 50 with a nyloc nut M8 are neededDiameter: 1 Wall thickness: 2.5 mmLength: 6500 mmMaterial: Galvanised Steel
0,00 €*