Steel tube galv. narrowed, 1'' / 2,5mm - L= 6,50 m - Bundle = 81pcs

Application: Even winding of drive cables in greenhouse shading systems Material: Impact-resistant plastic for long-term durability Capacity: Winding length 570 cm Installation: Can be retrofitted onto the drive shaft Feature: Two-shell design with hose clamp connection Packaging Unit: 12 pcs Cable drum 1" – type III ensures precise and uniform winding of drive cables in greenhouse shading systems, thanks to its pre-grooved plastic surface. This eliminates cable friction and guarantees a smooth operating path. The two-piece construction allows for retroactive installation on the drive shaft. The drum halves are secured with a hose clamp, while fixation on the shaft is carried out using a set screw. Made of impact-resistant plastic, the drum protects the cable and extends its lifespan. Suitable for cable diameters up to 3 mm.

This grooved cable drum ensures friction free, well-ordered winding and therefore a smooth movement of driving cable in shading systems .Two-halves model of the drum makes it possible to fasten it onto drive shaft subsequently. The two halves are connected quick and easy with U-bolt. To install the drum onto the drive shaft a headless screw is needed.The cable drum is made of high-impact resistant plastic, that is friendly to cables and therefore increases their durability. Can be used with cords with a diameter up to 3 mm For 34 mm drive shaftsCapacity of cable drum: up to 5,70 mMaterial: Cable drum: High impact resistant plasticU-Bolt: Galvanized steel

Application: Suitable for shading systems with suspended fabric and gable drive configuration Material: Impact-resistant plastic for high stability Function: Ensures accurate positioning of the drive shaft Packaging Unit: 25 pcs Offset bearing for 50/50 mm square tube is specifically designed for use in greenhouse shading systems featuring suspended fabric and a gable-driven layout. It accurately positions the drive shaft and supports smooth rotational movement during operation. Made from durable, impact-resistant plastic, this component provides high load-bearing capacity and long-term performance, even under challenging greenhouse conditions. Installation requires an M8 x 70 bolt and one M8 Nyloc nut (not included).

Our vertical bearing shaft supports 1" allows to set the drive shaft as close as possible to the gable end. In such a construction the shading screens do not set against the truss , but lay either over( in suspended system) or below ( in lay- flat system) the square tube, covering the whole area up to the gable end. The dalay of screens is basically not needed.The drive shaft can easily and quickly be pre-assembled on the ground. So dangerous, time-consuming works underneath the roof can be avoided.The bearings are attached onto the square tubes and locked with locking screws. If needed, they can be moved

Application: Bearing point for 34 mm drive shafts in ventilation systems Material: Galvanized steel Mounting height: Lower edge to shaft center: 62 mm Slide bearing: Highly wear-resistant bronze sintered ring Installation: Straight mounting holes for easy fastening Special features: Durable and suitable for high loads Slide bearing eliminates the need for lubricants The Fiberlane 1" support plate serves as a reliable bearing point for 34 mm drive shafts in greenhouse ventilation systems. Thanks to the highly wear-resistant bronze sintered slide bearing, it is especially durable and requires no additional lubrication.