Square tube, galv. 50 x 50 L=6,40 m

A functional square tube connector. Thanks to its easy -to- handle stick-system there is no need to weld square tubes. This component provides higher stability, quicker mounting and accuracy in alignment of square tubes in comparison with conventional welding.These square tube connectors are exclusively developed to be used with TGU-square tubes. Material: Steel, galvanized, exclusively to be used with Fiberlane-square tubes.

A functional square tube elbow connector. Thanks to its easy -to- handle stick-system there is no need to weld square tubes. This component provides higher stability and quicker mounting. Pre-construction of the elbow connector and the tube can be done down on the ground. Precise adjusting can be finished at the mounting position. The elbow connector can be set under any angle.This square tube elbow connector is exclusively developed to be used with TGU-square tubes.

The stable solution for fastening square tubes to double IP carriers. With the flange set, the pipes can be attached to the IP carriers without welding. This makes assembly easier and improves stability.Different sizes of IP carriers are covered with the flange set

This offset bearing has been developed for suspended shading systems with gable end drive. It brings the drive shaft to an optimal position and as a support point enables its rotation. The product has been built to hold trailing load. Material: High impact reistant plastic For mounting you will need the following parts: - M 8 x 70 bolt - M8 nyloc nut